登录

同安试点笔记

SCU APP安装指令参考

container install c_data   dataCenter.tar   -v /data/app/:/data/app/ -v /tmp/data:/tmp/data

container install c_uart   uartManager.tar -dev /dev/ttyRS0:/dev/ttyRS0 -dev /dev/ttyRS1:/dev/ttyRS1 -dev /dev/ttyRS2:/dev/ttyRS2 -dev /dev/ttyRS3:/dev/ttyRS3 -v /data/app/:/data/app/

container install c_cco     ccoRouter.tar -v /data/app:/data/app

container install c_map    mapManager.tar -dev /dev/ttySZ3:/dev/ttySZ3 -dev /dev/ttySZ4:/dev/ttySZ4 -dev /dev/ttySZ5:/dev/ttySZ5 -dev /dev/ttySZ6:/dev/ttySZ6 -dev /dev/gpio_sg:/dev/gpio_sg -dev /dev/spidev2.0:/dev/spidev2.0 -dev /dev/ttyS7:/dev/S7 -v /data/:/data/

container install c_bt    btManager.tar  -v /data/app/:/data/app/

container install c_rsp     rspSample.tar -p 9001:9001 -dev /dev/ttyRS0:/dev/ttyS3 -dev /dev/ttyRS1:/dev/ttyS5 -dev /dev/ttyRS2:/dev/ttyS0 -dev /dev/ttyRS3:/dev/ttyS4 -dev /dev/ttyS7:/dev/ttyS6 -dev /dev/gpio_sg:/dev/gpio_sg -dev /dev/encryption1:/dev/encryption1 -dev /dev/input_irq:/dev/input_irq -v /data/app:/data/app



container install c_acq    acMeter.tar -dev /dev/ledctrl:/dev/ledctrl -dev /dev/ttySZ3:/dev/ttySZ3 -dev /dev/ttySZ4:/dev/ttySZ4 -dev /dev/ttySZ5:/dev/ttySZ5 -dev /dev/ttySZ6:/dev/ttySZ6 -dev /dev/gpio_sg:/dev/gpio_sg -dev /dev/spidev2.0:/dev/spidev2.0 -dev /dev/ttyS7:/dev/ttyS7 -p 2404:2404 -v /data/app:/data/app


container install c_104 DaqoIEC104.tar -dev /dev/WAN2:/dev/WAN2  -v /data/app/:/data/app/ -p 2404:2404  
container install c_iot DaqoIOT.tar -v /data/app/:/data/app/  
container install c_pd DaqoPqAnalyzer.tar -v /data/app/:/data/app/ 
 
container install c_master_pd     -dev /dev/WAN2:/dev/WAN2 -p 2404:2404 -v /data/app:/data/app

container install c_gather_pd        ./apps/$1 -v /data/app/:/data/app/

container install c_analy_pd        ./apps/$1 -v /data/app/:/data/app/

老融合终端IP地址修改：

1.先修改FE0文件：iface FE0:1位置地址
2.然后覆盖 /etc/network/interfaces.d/FE0 文件

#iface FE0 inet manual
auto FE0 FE0:1
allow-hotplug FE0
iface FE0 inet static
address 192.168.1.101
netmask 255.255.255.0
#gateway 192.168.1.254
#dns-nameservers 192.168.1.240
iface FE0:1 inet static
address 192.168.2.201
netmask 255.255.255.0

SCU IP地址修改：

/lib/systemd/network/10-network-eth0.network

[Match]
Name=FE0

[Network]
#DHCP=yes
Address=192.168.0.150/24
Gateway=192.168.0.254
#DNS=8.8.8.8

物联网主站、配电主站 4G网卡配置：

配电主站地址： 172.17.253.3
配电主站端口： 2450

查看终端ESN:
sysadm@SCU:~$ devctl -e
esn :1311021400020462

查看4G网络IP地址(ifconfig)：

ppp-0: flags=4305<UP,POINTOPOINT,RUNNING,NOARP,MULTICAST>  mtu 1500
        inet 192.168.61.41  netmask 255.255.255.255  destination 10.64.64.64
        ppp  txqueuelen 3  (Point-to-Point Protocol)
        RX packets 5  bytes 62 (62.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 767  bytes 45761 (44.6 KiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

ppp-1: flags=4305<UP,POINTOPOINT,RUNNING,NOARP,MULTICAST>  mtu 1500
        inet 10.200.252.226  netmask 255.255.255.255  destination 10.64.64.65
        ppp  txqueuelen 3  (Point-to-Point Protocol)
        RX packets 55216  bytes 4293709 (4.0 MiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 77664  bytes 6504417 (6.2 MiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

根据提供的卡判断是物联网卡还是配电主站卡，其中10开头的是配电卡，192打头的是物联网卡,这里配电主站卡在ppp-1。

添加APN: 

wwan apn show dev ppp-0  
wwan apn add  
apn name:  CMIOTXMEPDMS.FJ  
usr name: card  
password: card 
authentication: chap
apn priority: 0
dev name: ppp-1

其他指令：
查看：wwan apn show dev ppp-0
重启：wwan modem reboot dev ppp-0

然后在/etc/ppp/ip-up 文件增加路由：
route add -net 172.17.253.3 netmask 255.255.255.255 dev ppp-1
route add -net 101.1.0.0 netmask 255.255.255.255 dev ppp-0

配电主站调试
查看加密代理是否在交互： sudo journalctl -f |grep proxy

物管平台调试
docker logs c_iot -f --tail 200

现场设备环境
变压器：CT: 2000/5，1000kVA

终端版本信息： 

sysadm@SCU:~$ ./Check_App_Version.sh 
Check Base App Version :
dataCenter App version : CV04.012
ccoRouter App version : CV01.015
mapManager App version : CV01.007
uartManager App version : CV04.015
btManager App version : CV01.005
acMeter App version : CV01.011
rspSample App version : CV01.007
wirelessDCM version: CV01.020
Check YX App Version :
taskManager App version : FJCV01.013
puAmr App version : FJCV01.012
lcMonitor App version : CV01.006
JcBoard version:

系统版本： 

sysadm@SCU:~$ version -d
software version:SV02.003
patch version:SV02.003.003

DaqoRTU APP调试指令： 

container stop c_rtu              
container uninstall c_rtu         
container install c_rtu DaqoRTU.tar -v /data/app/:/data/app/   

appm -S -c c_rtu -n DaqoRTU
docker exec -it c_rtu /bin/sh
cd /usr/local/extapps/DaqoRTU/bin

IEC104 APP调试： 

appm -S -c c_104 -n DaqoIEC104
docker exec -it c_104 /bin/sh
cd /usr/local/extapps/DaqoIEC104/bin
appm -s -c c_104 -n DaqoIEC104

HPLC切换成国网模式:
68 10 00 43 00 00 00 00 00 01 55 02 01 01 9D 16

最后更新于 2nd May 2022